Inductors
eGaN® FET Small Signal RF Performance
Even though the eGaN FET was designed and optimized as a power-switching device, it also exhibits good...
From Prototype to Post Deployment: Linux Decision Points
Developing embedded solutions can be a journey. Not all applications start at the same place in the journey...
Ultra-Low Noise Figure, High Gain Amplifier with High Linearity
This White Paper describes different trade-offs, design options, and implementation of a sub 1 dB low...
Ultra Low Noise Amplifiers
This white paper describes the performance and characteristics of two new ultra low noise LNAs from Skyworks....
Material Advances Enable New Generation of Power Inductors
Designers building power inductors for today's highly volume mobile markets face a difficult dilemma....
Fundamentals of Building a Test System
Most organizations do not consider production test a top priority, but it is a necessity to prevent major...
Medical power supplies: trends, challenges and design approaches
Medical electronic equipment is getting smaller. Of course, this could be said of all electronic equipment...
Optimizing EMI Input Filters for Switched Mode Power Supplies
Almost every switched-mode power supply (SMPS) needs an EMI (Electro Magnetic Interference) input filter...
Powering your FPGA Applications
Field-programmable gate arrays (FPGAs) have gained much attention and widespread application in the end...
Battery Simulation with DC power supply R&S®NGM200
This application note is about creating your own battery model for the RandS®NGM200, beyond the standard...
Synchronous Rectification for Forward Converters
In many switching power converters, rectifier diodes are used to obtain the DC output voltage. The conduction...
Sign up for Electronic Pro Tech Publish Hub
As a subscriber you will receive alerts and free access to our constantly updated library of white papers, analyst reports, case studies, web seminars and solution reports.