Flash Corruption: Software Bug or Supply Voltage Fault?
Flash memory is commonly used to store firmware in embedded systems. Occasionally, the firmware stored in the Flash memory in some systems is accidentally corrupted, preventing the system from booting up after power-on. Flash corruption is commonly associated with a software bug. However, it is also commonly understood that the probability of Flash corruption increases either during power cycling tests or during margining tests.
This article examines Flash corruption and its causes beyond a software bug, and suggests methods to minimize the corruption.
Download this whitepaper to find out more.
Read More
By submitting this form you agree to Lattice Semiconductor Corporation contacting you with marketing-related emails or by telephone. You may unsubscribe at any time. Lattice Semiconductor Corporation web sites and communications are subject to their Privacy Notice.
By requesting this resource you agree to our terms of use. All data is protected by our Privacy Notice. If you have any further questions please email dataprotection@techpublishhub.com
Related Categories: Communication, Comparators, Embedded, Microcontrollers, Power, Processors, Resistors
More resources from Lattice Semiconductor Corporation
Pre-tested System-on-Chip Design Accelerates PLD Development
Many moderate size Programmable Logic Device (PLD) designs, especially those in control plane applications, consist of a number of interfaces inter...
LEVERAGING FPGA AND CPLD DIGITAL LOGIC TO IMPLEMENT ANALOG TO DIGITAL CONVERTERS
An Analog to Digital Converter (ADC) is a common analog building block and almost always is needed when interfacing digital logic, like that in an ...
Implementing High-Speed DDR3 Memory Controllers in a Mid-Range FPGA
Implementing a highspeed, high-efficiency DDR3 memory controller in a FPGA is a formidable task. Until recently, only a few high-end (read: expensi...
